After a short hiatus and recovery from this past Thanxgiving holiday, I couldn't wait to get back and gather the materials needed to start my 3D Incursion board.
If you recall from a previous post, I created wall sections (both concrete and stone) to represent what was on the board and give it an added dimension.
(click on the pix to enlarge)
 |
| AT-43 TacArm for scale reference next to 2" high x 1 1/2" thick concrete and stone wall sections. |
This was just a mockup and my intent is to enlarge the board using 2" squares in lieu of the game's 40mm. I found that this increased square area would lend better to using over-sized models in the future.
 |
| 2"x2" Tiles |
 |
| Tiles laid out on 1/4" Masonite |
 |
| New wall sections will have to be built to match the 2" incremental lengths however the wall thickness I'll keep to about 1 1/2". |
 |
| Beautifully sculpted lab doors and general control panels (GCP) by Fenris Games. Door frames will have to be built to nestle the lab doors between wall sections. |
 |
| Here's my scratch built versions of the game Objective markers; Left to Right: Doomsday Machine, Zombie Pinger and Caved In markers. |
 |
| Test fit using AT-43 Red Blok Mechs and Horrorscape Zombies as proxies |
 |
| This'll work for the actual Incursion APE and Hans the Hunter over-sized models. |
Coming up: details, details, details...
This is superb Sir, I've just discovered Incursion and my immediate reaction was 'Ooh, 3d Board!' Good job and a fine inspiration.
ReplyDelete